How To Draw Circle On Wood

1
Cut string that'due south 1–ii inches (2.5–5.1 cm) longer than your desired radius. The circle you draw will accept a diameter that's twice as long as the string you use, but you should cut it one–2 inches (2.five–v.1 cm) longer than you lot desire at start since y'all'll lose some of the length when you tie a loop at each cease.^[1]
- For example, if you want your circle to be 4 inches (ten cm) across, then your desired radius would be 2 inches (five.one cm) since the radius is equal to one-half of the diameter. Therefore, you'd cut the piece of cord to be about iii–4 inches (seven.half-dozen–10.2 cm) long so you have actress cord on each terminate to necktie the loops with.
ii
Tie a small loop at each end of the string. Y'all'll utilize one of the loops to attach the string to a pivot and the other loop to adhere it to a pencil. The size of the loops doesn't demand to be precise, simply make sure they're big enough to fit around a pencil and pivot but not so large that they use up a lot of the string that you cutting.^[2]
- When you're finished tying the loops, y'all can mensurate the length of the string to decide what the exact radius of your circumvolve will be. If the radius is too short, you can ever cut a longer piece of cord and endeavor again.
Advert
3
Place a piece of paper over some cardboard, styrofoam, or cork lath. Any kind of material will work as long every bit yous're able to press a pivot into information technology. This base under the paper volition give the pivot something to stick into and aid concord it in place every bit you utilize information technology to draw your circumvolve.
- If you're drawing your circle onto a slice of thick material, like foam poster board or canvass, you can skip this pace.
- If you don't take annihilation to employ equally a base of operations under your sheet of newspaper, you lot can endeavour holding the pin in place on the paper with your fingers instead.
4

Push a pin through the newspaper where you lot want the center of your circle to be. Whatever kind of push pin will work, although the shorter the pin, the easier it will be to piece of work with (since a tall pin might stick upwards more and be less stable). Brand certain information technology'south non also shut to the border of the paper or else your circle might go off the page when you draw it.^[three]
five
Loop one end of the string over the pin. Don't worry well-nigh tightening the loop. Equally long every bit it'due south wrapped around the pin, yous're all set.^[4]
- Information technology doesn't matter what end of the cord you wrap around the pin. Simply brand sure the loop on the other cease is large enough to wrap effectually a pencil.
Advert

1
Loop the other end of the string around the end of a pencil. Simply slide the tip of the pencil into the loop so the cord is wrapped around the pencil. It's OK if the loop slides downward the pencil. You'll be pulling information technology taut later on and so it stays in identify.^[5]
- You don't have to use a pencil to depict your circle—y'all can use a pen, marker, colored pencil, or another drawing utensil every bit long as the loop fits around it.
ii
Identify the tip of the pencil on the paper so the string is pulled taut. Pull the pencil away from the pin until the string is completely taut. Then, place the tip of the pencil down. This is where the edge of your circle will be.^[6]
- Don't pull on the string as well hard or you lot could pull the pin out.
3
Draw a circle with the pencil, keeping the string taut as yous go. To draw your circle, slowly move the pencil in a circular motion around the pivot in the center, holding the pencil upwardly straight and not at an bending. Go on gently pulling the pencil away from the pin in the center so that the string stays taut and your circle is fifty-fifty all the way around.^[7]
- If you don't keep the cord taut, you won't end upwards with a perfect circle. If your hand slips and you lot make a error, just erase what you've fatigued and start over.
4

Remove the pin when you're finished drawing your circle. If yous desire to draw another circle, you can push the pin into a different spot on the paper and repeat the process. Otherwise, ready the pin and cord aside for the next time you demand to depict a perfect circle!

Advertizing

Ask a Question

200 characters left

Include your email address to go a bulletin when this question is answered.

Submit

Thanks for submitting a tip for review!

Things You'll Need

Newspaper
Pencil
Cord
Pair of scissors
Pivot
Cardboard, styrofoam, or cork lath

About This Article

Commodity Summary X

To draw a perfect circle using a pin, start by cutting a piece of cord that's 1 to two inches longer than your desired radius and tying a pocket-size loop at each terminate. So, place a piece of paper over some cardboard or styrofoam, button a pivot through the center of the paper, and loop 1 stop of the string over the pin. Adjacent, loop the other end of the string around the end of a pencil, and pull the pencil away from the pivot so the cord is completely taut. Finally, identify the tip of the pencil on the paper and describe a circle, keeping the string taut every bit you lot go. To learn more, including how to keep the pin in place if you don't take whatever paper-thin or styrofoam, go on reading.

Did this summary help you lot?

Thanks to all authors for creating a page that has been read 29,916 times.